7
8
9
10
11
12
3.
Gently push down the full-size M.2 SSD on top of the screw hole and fasten it using one
of the 3mm round screw. Refer to the illustration for the location of the screw hole.
4.
Follow steps 7-8 on pages 4-5 under the
Installing or upgrading memory modules
section
of this guide to replace the bottom cover back on your VivoMini.
2.
Align and insert the full-size M.2 SSD into its slot inside the VivoMini. Refer to the illustration
for its location.
To install or upgrade a full-size M.2 SSD:
1.
Follow steps 1-5 on pages 2-3 under the
Installing or upgrading memory modules
section
of this guide to remove the bottom cover of your VivoMini.
Installing 2.5” HDD
To install the 2.5” HDD:
1.
Follow steps 1-5 on pages 2-3 under the
Installing or upgrading memory modules
section
of this guide to remove the bottom cover of your VivoMini.
2.
Align the bundled bracket on each side of the HDD and insert four (4) screws to secure
the 2.5” HDD to the bracket.
3.
Connect the bundled HDD cable to the HDD, then secure the HDD and bracket to the
bottom cover of your VivoMini using the four (4) bundled screws.
4.
Remove the tape covering on the HDD cable and stick the cable to the bottom cover of
your VivoMini as shown in the illustration below.
5.
Remove the three (3) screws from the USB 3.0 expansion card and remove the USB 3.0
expansion card.
7.
Replace the USB 3.0 expansion card and secure it with the screws removed before..
6.
Lift the SATA connector latch up (A) before inserting the HDD cable, then insert the
HDD cable into the connector and push the latch down to secure the HDD cable (B).
5.
Follow steps 7-8 on pages 4-5 under the
Installing or upgrading memory modules
section
of this guide to replace the bottom cover back on your VivoMini.
4.
Connect the black antenna to MAIN or and the white antenna to AUX or . Refer
to the illustration for the right installation procedure.
NOTE: A soft clicking sound indicates that the antenna has been securely attached on
the wireless card.
Installing or upgrading the wireless card
To install or upgrade the wireless card:
1.
Follow steps 1-5 on pages 2-3 under the
Installing or upgrading memory modules
section
of this guide to remove the bottom cover of your VivoMini.
2.
Align and insert the wireless card into the lower slot inside the VivoMini.
3.
Gently push down the wireless card on top of the screw holes and fasten it using a
3mm round screw.
Your VivoMini includes a mini-PCIe slot for half-size wireless and Bluetooth adapters.
Refer to http://www.asus.com for the list of compatible wireless and Bluetooth adapters.
8.
Follow steps 7-8 on pages 4-5 under the
Installing or upgrading memory modules
section
of this guide to replace the bottom cover back on your VivoMini.