ASUS PRIME H610M-R D4
1-3
8. USB 3.2 Gen 1 header
The USB 3.2 Gen 1 header allows you to connect a USB 3.2 Gen
1 module for additional USB 3.2 Gen 1 ports. The USB 3.2 Gen 1
header provides data transfer speed of up to 5 Gb/s.
The USB 3.2 Gen 1 module is purchased separately.
9. USB 2.0 headers
The USB 2.0 headers allow you to connect a USB module for additional USB
2.0 ports. The USB 2.0 headers provide data transfer speed of up to 480 Mb/s.
DO NOT connect a 1394 cable to the USB connectors. Doing so will
damage the motherboard!
The USB 2.0 module is purchased separately.
10. Chassis Intrusion header (4-1 pin CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
11. Clear CMOS header
This header allows you to clear the CMOS RTC RAM data of the system setup
information such as date, time, and system passwords.
To erase the RTC RAM:
1. Turn OFF the computer and unplug the power cord.
2. Use a metal object such as a screwdriver to short the two pins.
3. Plug the power cord and turn ON the computer.
4. Hold down the <
Del
> key during the boot process and enter BIOS Setup to re-
enter data.
If the steps above do not help, remove the onboard battery and short the two pins again to
clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the battery.
12. COM Port header
This header is for a serial (COM) port. Connect the serial port module cable
to this header, then install the module to a slot opening at the back of the
system chassis.
The COM port module is purchased separately.
USB3+5V
IntA_P1_SSRX-
IntA_
GND
IntA_P1_SSTX-
IntA_
GND
IntA_P1_D-
In
GND
PIN 1
USB3+5V
IntA_P2_SSRX-
IntA_
GND
IntA_P2_SSTX-
IntA_
GND
IntA_P2_D-
In
PIN 1
USB+5V USB_P9- GND NC
USB+5V
USB_P14-
GND
+5VSB_MB
Chassis Signal GND
CHASSIS
CLRTC
+3V_BAT
GND
PIN 1
PIN 1
DCD TXD GND RTS
RI
RXD DTR DSR CTS
COM
