1-6
•
Chassis intrusion header (2-pin CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch. Connect one
end of the chassis intrusion sensor or switch cable to this header. The chassis intrusion
sensor or switch sends a high-level signal to this connector when a chassis component
is removed or replaced. The signal is then generated as a chassis intrusion event.
19. Thunderbolt™ header
The Thunderbolt™ header allows you to connect an add-on
Thunderbolt™ I/O card that supports Intel
®
’s Thunderbolt™
Technology, allowing you to connect Thunderbolt™-enabled
devices to form a daisy chain-configuration.
•
The add-on Thunderbolt™ I/O card and
Thunderbolt™ cables are purchased separately.
•
The Thunderbolt
TM
card can only be used when
installed to the PCIEX16(G3) slot. Ensure to install
your Thunderbolt
TM
card to the PCIEX16(G3) slot.
•
Please visit the official website of your purchased
Thunderbolt card for more details on compatibility.
20. SPI TPM header
This header supports a Trusted Platform Module (TPM)
system with a Serial Peripheral Interface (SPI), allowing you
to securely store keys, digital certificates, passwords, and
data. A TPM system also helps enhance network security,
protects digital identities, and ensures platform integrity.
The SPI_TPM module is purchased separately.
21. Q-LEDs
The Q-LEDs check key components (CPU, DRAM, VGA, and booting devices) during the
mothboard booting process. If an error is found, the critical component’s LED stays lit up until
the problem is solved.
The Q-LEDs provide the most probable cause of an error code as a starting point for
troubleshooting. The actual cause may vary from case to case.
PIN 1
FORCE_PWR
CIO_PLUG_EVENT
SLP_S3# SLP_S5#
GND
RTD3_SW
I2C_SCL I2C_SDA I2C_IRQ# RTD3_POWER_EN S_SLP_S0#_IDLE PERST_N WAKE#
TB_HEADER
TPM
PIN 1
VCCSPI
S_PLTRST#
NC
+3V_SPI
F_SPI_CS0#_R
T_SPI_MISO
F_SPI_HOLD#_R
S_SPI_TPM_IRQ#
S_SPI_TPM_CS2#
F_BIOS_WP#_R
GND
T_SPI_CLK
T_SPI_MOSI
Chapter 1: Product Introduction