10. Front panel audio connector (10-1 pin AAFP)
This connector is for a chassis-mounted front panel audio I/O module that supports
either High Definition Audio or AC`97 audio standard. Connect one end of the front
panel audio I/O module cable to this connector.
P5G41-M EVO
P5G41-M EVO Analog front panel connector
AAFP
PIN 1
GN
D
PRESENCE#
SENSE1_RETUR
SENSE2_RETUR
PORT1
L
PORT1
R
PORT2
R
SENSE_SEND
PORT2
L
HD-audio-compliant
pin definition
PIN 1
AGND
NC
NC
NC
MIC
2
MICPWR
Line out_
R
NC
Line out_L
Legacy AC’97
compliant definition
If you want to connect a high-definition front panel audio module to this connector, ensure
that the
Front Panel Type
item in the BIOS is set to
[HD Audio
]. If you want to connect an
AC97 front panel audio module to this connector, set the item to
[AC97]
. See page 2-8 for
details.
11. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
P5G41-M EVO
P5G41-M EVO Chassis intrusion connector
GND
Chassis Signal
+5VSB_MB
CHASSIS
1-16
Chapter 1: Product introduction
Summary of Contents for P5G41-M EVO
Page 1: ...Motherboard P5G41 M EVO ...
Page 10: ... ...
