iGPU Memory [64M]
Allows you to select the pre‑allocated or fixed graphics memory size for DVMT 5.0
used by the IGD. Configuration options: [32M] [64M] [96M] [128M] [160M] [192M]
[224M] [256M] [288M][320M] [352M] [384M] [416M] [448M] [480M] [512M]
PUNIT Power Configuration [Enabled]
Enables or disables the Punit Power configuration. Configuration options: [Enabled]
[Disabled]
Svid Configuration [Svid Config 3]
Allows you to select the SVID configuration. Configuration options: [Svid Config 0]
[Svid Config 1] [Svid Config 3]
2.5.4
SATA Configuration
STAT Controller [Enabled]
Allows you to enable or disabled the SATA device. Configuration options: [Disabled]
[Enabled]
The following items appear only when you set the STAT Controller
item to
[Enabled]
.
SATA Mode Selection [AHCI]
Allows you to set the SATA configuration.
[AHCI]
Set to [AHCI] when you want the SATA hard disk drives to use the
AHCI (Advanced Host Controller Interface). The AHCI allows the
onboard storage driver to enable advanced Serial ATA features that
increases storage performance on random workloads by allowing the
drive to internally optimize the order of commands.
Aggressive LPM Support [Auto]
This item appears only when you set the previous item to [AHCI] and allows you to
enable or disable PCH entering link power state aggressively. Configuration options:
[Auto] [Disabled] [Enabled]
S.M.A.R.T. Status Check [On]
S.M.A.R.T. (Self‑Monitoring, Analysis and Reporting Technology) is a monitor system.
When read/write of your hard disk errors occur, this feature allows the hard disk to
report warning messages during the POST. Configuration options: [On] [Off]
SATA6G_1 / SATA6G_2 (Gray)
Allows you to enable or disable the SATA port. Configuration options: [Disabled] [Enabled]
The following items appear only when you set the SATA6G_1 /
SATA6G_2 item to
[Enabled]
.
Hot Plug [Disabled]
Allows you to enable or disable the SATA Hot Plug Support. Configuration options:
[Disabled] [Enabled]
2-16
Chapter 2: Getting started
