A S U S K 8 S - L A ( S a l m o n )
A S U S K 8 S - L A ( S a l m o n )
A S U S K 8 S - L A ( S a l m o n )
A S U S K 8 S - L A ( S a l m o n )
A S U S K 8 S - L A ( S a l m o n )
1 3
1 3
1 3
1 3
1 3
2 .
2 .
2 .
2 .
2 .
I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I M A R Y _ I D E , S E C O N D A R Y _ I D E )
I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I M A R Y _ I D E , S E C O N D A R Y _ I D E )
I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I M A R Y _ I D E , S E C O N D A R Y _ I D E )
I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I M A R Y _ I D E , S E C O N D A R Y _ I D E )
I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I M A R Y _ I D E , S E C O N D A R Y _ I D E )
These connectors are for Ultra DMA 100/66 signal cables. The Ultra
DMA 100/66 signal cable has three connectors: a blue connector for
the primary IDE connector on the motherboard, a black connector for
an Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive),
and a gray connector for an Ultra DMA 100/66 IDE master device (hard
disk drive). If you install two hard disk drives, you must configure the
second drive as a slave device by setting its jumper accordingly. Refer
to the hard disk documentation for the jumper settings.
•
Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
•
Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
K8S-LA
K8S-LA IDE connectors
NOTE:
Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
SECONDAR
Y_IDE
PIN 1
PRIMAR
Y_IDE
PIN 1
Summary of Contents for K8S-LA (Salmon)
Page 1: ...Motherboard K8S LA Salmon ...
