Asus Grouper-GL8E, User Manual

Page: 8 / 20

4 4 4 4 4 A S U S P T G D 1 - L A ( G r o u p e r - G L 8 E ) m o t h e r b o a r d A S U S P T G D 1 - L A ( G r o u p e r - G L 8 E ) m o t h e r b o a r d A S U S P T G D 1 - L A ( G r o u p e r - G L 8 E ) m o t h e r b o a r d A S U S P T G D 1 - L A ( G r o u p e r - G L 8 E ) m o t h e r b o a r d A S U S P T G D 1 - L A ( G r o u p e r - G L 8 E ) m o t h e r b o a r d
3. System memory
The motherboard comes with four Double Data Rate (DDR) Dual Inline
Memory Module (DIMM) sockets. These sockets support up to 4GB system
memory using 184-pin unbuffered non-ECC 2.6V DDR SDRAM.
The following figure illustrates the location of the DDR DIMM sockets.
Memory configurations Memory configurations
Memory configurations Memory configurations
Memory configurations
You can install 128MB, 256MB, 512MB, and 1GB DDR SDRAM DIMMs into
the DIMM sockets using the memory configurations in this section.
Important notes on memory configurations Important notes on memory configurations
Important notes on memory configurations Important notes on memory configurations Important notes on memory configurations
• Installing DDR DIMMs other than the recommended configurations
may cause memory sizing error or system boot failure. Use any of
the recommended configurations in Table 1.
• Install only i d e n t i c a l i d e n t i c a l i d e n t i c a l i d e n t i c a l i d e n t i c a l (the same type and size) DDR DIMM pairs
using the recommended configurations.
• Make sure that the memory frequency matches the CPU FSB
(Front Side Bus). Refer to Table 2 on the next page.
• This motherboard does not support double-sided 16-bit DDR DIMMs.
• Do not create a three-DIMM configuration in dual-channel mode. The
third DIMM is ignored in the dual-channel operation.
PTGD1-LA
PTGD1-LA 184-Pin DDR DIMM Sockets
DIMM_A
1
DIMM_A
2
DIMM_B
1
DIMM_B
2