88
[RIP-disabled interfaces]
You can specify an L3 interface as RIP-disabled interface if you do not want
this interface to deal with any RIP message, either incoming or outgoing.
CLI command :
l3 rip interface remove
<interface name/* for all>
5.3.4 Bridge
Commands
[Spanning Tree is]
[
STP Enabled/ RSTP Enabled/ Disabled
]
Allows user to specify whether the switch participates in the Spanning Tree
Protocol (STP/ RSTP).
CLI command :
l2 stp
start <stp / rstp>
CLI command :
l2 stp
stop
[Hello Time]
[Forward Delay]
[Max Age]
[Bridge Priority]
Displays the current STP/RSTP bridge parameters setting.
CLI command :
l2 stp bridge set
Hello Time (1..10 seconds):[
old Hello Time
]
<new Hello Time>
Max Age (6..40 seconds):[
old Max Age
]
<new Max Age>
Forward Delay (4..30 seconds):[
old Forward Delay
]
<new Forward
Delay>
Bridge Priority (0..61440):[
old Bridge Priority
]
<new Bridge Priority>
[Priority]
[Path Cost]
[Edge Port]
[Point-to-point]
Displays the current STP/RSTP ports parameters setting.
CLI command :
l2 stp port set
Port Settings (all,…):[all]
<select a port number, or just type ‘all’ to
iteratively config>
Port <port number> Priority (0..240):[old port Priority]
<new port Priority>
Summary of Contents for GIGAX 2024M
