Asus AAEON FWS-2365, User Manual

Page: 39 / 95

Chapter 3 – AMI BIOS Setup 39
Deskt
op
Net
work
Ap
plian
ce
FW
S-
2365
3.1 System Test and Initialization
The system uses certain routines to perform testing and initialization during the boot
up sequence. If an error, fatal or non-fatal, is encountered, the system will output a few
short beeps or display an error message. The system can usually continue the boot up
sequence with non-fatal errors.
The system configuration verification routines check the current system configuration
against the values stored in the CMOS memory and BIOS NVRAM. If a system
configuration is not found or an error is detected, the system will load the default
configuration and reboot automatically.
There are four situations in which you will need to setup system configuration:
1. You are starting your system for the first time
2. You have changed the hardware attached to your system
3. The system configuration was reset by the Clear-CMOS jumper
4. The CMOS memory has lost power and the configuration information has been
erased.
The system CMOS memory has an integral lithium battery backup for data retention.
However, you will need to replace the battery unit when it runs down.