ASUS PRIME H410M-E
1-3
•
M.2 slot (Key M), type 2242/2260/2280 (supports PCIe 3.0 x2 & SATA modes).
•
M.2 slot supports data transfer speeds up to 16Gb/s.
•
When a device in SATA mode is installed on the M.2 slot, SATA6G_2 port cannot be
used.
7. SATA 6Gb/s ports
The SATA 6Gb/s ports allow you to connect SATA devices such as optical disc drives and
hard disk drives via a SATA cable.
8. USB 3.2 Gen 1 header
The USB 3.2 Gen 1 header allows you to connect a USB 3.2 Gen
1 module for additional USB 3.2 Gen 1 ports. The USB 3.2 Gen 1
header provides data transfer speeds of up to 5 Gb/s.
The USB 3.2 Gen 1 module is purchased separately.
9. USB 2.0 headers
The USB 2.0 headers allow you to connect a USB module for additional USB
2.0 ports. The USB 2.0 headers provide data transfer speeds of up to 480 Mb/s
connection speed.
DO NOT connect a 1394 cable to the USB connectors. Doing so will
damage the motherboard!
The USB 2.0 module is purchased separately.
10. Clear CMOS header
This header allows you to clear the CMOS RTC RAM data of the system setup
information such as date, time, and system passwords.
To erase the RTC RAM:
1. Turn OFF the computer and unplug the power cord.
2. Use a metal object such as a screwdriver to short the two pins.
3. Plug the power cord and turn ON the computer.
4. Hold down the <
Del
> key during the boot process and enter BIOS setup to re-
enter data.
If the steps above do not help, remove the onboard battery and short the two pins again to
clear the CMOS RTC RAM data. After clearing the CMOS, reinstall the battery.
11. COM Port header
This header is for a serial (COM) port. Connect the serial port module cable
to this header, then install the module to a slot opening at the back of the
system chassis.
PIN 1
USB+5V USB_P1- GND NC
USB+5V USB_P2-
GND
CLRTC
+3V_BAT GND
PIN 1
USB3+5V
IntA_P1_SSRX-
IntA_
GND
IntA_P1_SSTX-
IntA_
GND
IntA_P1_D-
In
GND
PIN 1
USB3+5V
IntA_P2_SSRX-
IntA_
GND
IntA_P2_SSTX-
IntA_
GND
IntA_P2_D-
In
PIN 1
DCD TXD GND RTS
RI
RXD DTR DSR CTS
