© 2006 A
STROFLEX
E
LECTRONICS
– A
LL RIGHTS RESERVED
8
S
YSTEM STATUS CHIRPS
The siren will chirp when arming/disarming the system. The pattern of chirps will audibly report
the system’s status as described below.
Action
Number of Chirps
Description
Arm 1
System
armed
Arm
1 (3 second delay), 1
System armed with zone active
Disarm 2
System
disarmed
Disarm
4
System disarmed with zone violation report
Disarm
5
System disarmed NPC
®
active
T
ABLE OF ZONES
The zone number is the number of LED flashes used by the system to identify that input. The
standard input assignments are listed below, along with spaces to write in any optional sensors or
switches you have had installed.
Zone Number
of LED Flashes
Description
Dealer-Installed
Options
1
Used for hood/trunk pin-switches
2
An impact was detected by the shock sensor
3
Door switch trigger
4 Optional
sensors
5 Ignition
trigger
I
NTERPRETING ZONE DIAGNOSTICS
Warn Away responses are not reported by arming or disarming diagnostics. If you receive a
Bypass notification when arming or a Tamper Alert notification when disarming, look at the LED.
Active or triggered zones will be indicated by a pattern of blinks by the LED.
Example
If zone 3 was active or triggered, the LED will blink three times with a two-second pause. Then it
will blink three times again, and repeat until the ignition is turned on.
Note: Your system stores the last two triggered zones in memory. If your system has
been triggered but the LED has been reset by turning on the ignition, your dealer can
still recall the last two zones that were triggered. Contact your dealer for details.
