P
AGE NOTIFICATION
The remote control can be programmed to notify the user of a page (audibly beeping if the
vehicle’s status changes, e.g. door unlocked, engine started, vehicle violation, etc.). On the LCD
remote press
to select page On/Off. One beep is page On, Two beeps is page Off. When
programmed off the remote will not give any notification that a page was received from the
vehicle.
Page notification
Programming response
ON
1 beep, page notification ON
OFF
2 beeps, page notification is OFF
NOTE: If programmed Off, no alarms will
be notified to the remote. Command information
(armed/disarmed) will be notified to the remote.
T
O EXIT PROGRAMMING MODE
The LCD remote control will exit programming mode after 5- seconds of inactivity and will emit 1
long beep.
Using your system
The buttons described in this manual correspond to the standard configuration. Remember, this is
not the only way your transmitter may be set up. It can be custom configured to meet your
needs. See your installer for additional details.
A
CTIVE ARMING
You can arm the system by pressing
of your remote for one second. When the system arms,
from the vehicle you will hear a short siren sound, or chirp, and see the parking lights flash once.
If the power door locks are controlled by the system, the doors will also lock.
While the system is armed, the in-vehicle’s status LED will flash approximately once per second,
indicating that the system is actively protecting your vehicle. If you hear a second chirp after
arming and note that the in-vehicle’s status LED is flashing in groups, see the Diagnostics Section
of this guide. This extra chirp is called Bypass Notification.
The LCD remote responds to active arming with one beep and the icon will flash 5-times to
indicate successful arming of the system.
If the LCD remote beeps twice after arming, the system has detected an active sensor that should
be checked. For example, a door open icon will be displayed flashing 5-times on the LCD screen.
7
© 2006 Astroflex Electronics - All rights reserved
