2
10-27-97 TI692-93-3
GAGING INSTRUCTIONS
Gaging the Tool requires Astro part # ATK 6000 Gage Kit
Assembly.
1.
Install Astro Gage Positioner part # 4697 (MS3196-1)
2.
Close the Handles to the fully closed position.
3.
Using gage part # 621074 (MS3196-3), hold the Tool
closed, insert the GO Pin into the Indenter opening as
shown, see figure # 3. The Gage must pass freely between
the Indenter tips.
4.
Using gage part # 621074 (MS3196-3), hold the Tool
closed, insert the NO GO Pin into the Indenter opening.
The Gage Pin must NOT go between the Indenter tips.
Indenter
Gage Pin
Figure # 3
CAUTION:
DO NOT CRIMP GAGE.
TOOL DAMAGE WILL RESULT.
To verify ratchet hold and release, insert NO-GO Gage Pin
into the Tool and close the Tool carefully, until the Indenters
lightly grip the Gage Pin.
DO NOT CRIMP GAGE.
When
the Handles are released the Tool shall not return to the full
open position.
Gaging Data
Positioner Installed in
Tool Frame
In-Service
Gaging
10692
MS3191-1
GO
.0001
NO-GO
.0001
MS3191-20A
.0310
.0410
MS3191-16A
.0420
.0520
MS3191-12A
.0630
.0730
MS3191-20B
.0420
.0520
MS3191-16B
.0580
.0680
MS3191-20C
.0310
.0410
MS3191-22D
.0310
.0410
MS3191-16D
.0460
.0560
MS3196-1 GAGE
.0330
.0410
TOOL SERVICE
Astro Tool's 10692 Crimp Tool is designed for long,
reliable service. If the Tool becomes inoperative or does not
gage properly, it is suggested that you contact our Customer
Service Department for a Return Goods Authorization number
and return the Tool to our factory.
Upon receipt of the Tool, Astro will inspect and overhaul
each Tool to put the Tool back into acceptable and efficient
operating condition. Worn parts will be replaced or repaired.
Please note that Astro's Quality Control system is traceable to
The National Institute of Standards and Technology (N.I.S.T.).
Service charges for tools not under warranty will be
advised upon request.
Parts that Astro deems to have been damaged due to
neglect, misuse or accident; and parts that have been altered or
repaired by persons other than Astro Tool Corp. employees
will be replaced subject to additional charge for such parts.
TOOL HAS BEEN PERMANENTLY LUBRICATED
AT THE FACTORY
DO NOT OIL
ASTRO TOOL CORP. MANUFACTURERS OF INSERTION, REMOVAL,
CRIMP TOOLS AND CONNECTOR SERVICE KITS
ASTRO TOOL CORPORATION
21615 S.W. T-V HWY.
BEAVERTON OREGON 97003
503-642-9853
FAX 503-591-7766
