FOLLOWER HANDLE
GREASE
CARTRIDGE
CARTRIDGE LOADING
DISPENSER
LOADING
CONTAINER
TUBE
FOLLOWER
ROD
ADG100
GREASE GUN DRILL ADAPTER
MODEL:
PRODUCT TYPE:
Page 5
VIII. INSTRUCTIONS FOR 3 DIFFERENT LOADING METHODS OF GREASE GUN
RECOMMENDATION:
1. If loading grease by cartridge, note that the Rubber Plunger may change shape over time due to
prolonged squeezing of grease cartridge. Inspect during changes.
2. A misshaped rubber plunger may then cause a small amount of leak-by at the stopper and plunger
handle when switching to Dispenser or Bulk loading grease.
3. Thus it is recommended to pick a method of grease loading and stick to this method in the future for
best results.
FOLLOW THESE STEPS CAREFULLY BEFORE USING THIS GUN
CARTRIDGE LOADING
1. Remove gun head from container tube.
2. To remove an empty cartridge, pull back on the follower handle until the follower
rod is fully extended. Then, release the stopper lock and allow the follower handle
to lower the empty cartridge from the container tube. Pull back on the follower
handle. When the follower rod is fully extended, the stopper should hold the
rod extended.
3. Remove the caps from both ends of the new grease cartridge and insert the
open cardboard end of the cartridge into the container tube with the metal
rimmed end out.
4. Loosely assemble the gun head and the container tube. Release the stopper lock
and allow the follower handle to go free.
5. Unscrew the container tube 1-2 turns from the gun head and push down on the
follower handle until grease oozes from the outlet of the gun head. Tighten
container tube into the gun head securely.
• Please make sure that the end of the grease cartridge that has been inserted
into the container tube is not damaged, had its cardboard rim folded and
remains in an exact round shape. Otherwise the plunger rubber will be
prevented from entering into the grease cartridge and grease cannot be forced
out. If this case happens correct the above errors. Grease can be pumped out
only it the above errors have been corrected.
• Do not re-use the empty grease cartridge again after using it.
• Application of some grease on the plunger rubber will make it easier to enter
into the grease cartridge.
DISPENSER LOADING
1. Remove slotted plug from head assembly and insert the proper loader fitting that
adapts to pump being used.
2. Extend level out on the grease gun and insert the loader fitting into pump adapter and fill.
NOTE : Always remove used cartridge from gun when bulk filling.
