Product Type:
Model:
7346
15L (4 GAL) PROFESSIONAL MANUAL/PNEUMATIC
FLUID EXTRACTOR WITH GAUGE
Page 4
PRODUCT INFORMATION
1. Please always wear safety goggles.
2. Keep out of reach of children.
3. Do not use the unit to extract or store dangerous chemicals, poisons, acids, alkaline, or solvents. If by chance,
liquids such as these are used in the unit, it must be immediately, drained, washed and cleaned.
4. Flammable liquids such as petrol, diesel or kerosene may be extracted or siphoned with the unit but they must
not be stored in it.
5. Do not dismantle, tamper with or adapt the unit for any other purpose than what it was originally intended for.
6. Do not drop, throw or mishandle the unit.
7. Do not store either, the unit or suction tubes near or in areas of high temperature, direct sunlight, rain or snow.
8. When extracting flammable liquids, caution should be used due to flammable vapors.
9. The temperature of the fluid should be between 33°F - 212°F when operating. (APPLICATIONS)
When using the manual fluid
extractor unit to extract engine oil,
first you need to make sure the
vehicle is level, and then run the
engine for about 5 minutes to warm
the oil and allow any sludge or
contamination within the oil to mix.
Turn the handle on top of the (-02) upper cover. (Check before the operation. 4.
Check if the tube is inserted to the bottom of the engine.)
After confirming that the tubes are secured, the barrel will create vacuum by pumping
the handle up/down. (up/down cycle, just 6~10 pumps to confirm whether the inside
of the barrel created vacuum)
After the barrel creates vacuum, the oil body of the
engine will be draining into the extractor barrel.
Insert the hose into the hole of the
dipstick (4. to be inserted to the
bottom of the engine), and then
connect the other end of the hose to
the extension hose provided.
Installation pipe
Pull out the
engine oil dipstick
For extraction all types of engine oils, transmission fluids, lubricants, from motor cars, motor bikes, marine
engines, stationary engines, large and small industrial machinery, as well as non lubricants such as water
from fish tanks, etc...
Turn the handle up
Fix the assembly 2 on the
1 to complete the assembly
Installation and storage tube
Connect air supply
Insert the tubing
1
2
