3
KeYPRo installation
Caution:
the KeYPRo fits closely around the keypad controller. You must work it gently into place. if you force the
rubber casing while it is being installed on your keypad, you may tear the rubber.
Procedure:
1. if you are installing a new KeYPRo, or if your old KeYPRo was
removed completely from the keypad and cable, start by insert-
ing the plug end of the cable into the KeYPRo as shown at right.
You must feed the cable from the top/front side of the keypad
protector.
2. feed most of the cable through the opening, but do not pull it
all the way through at this time.
3. insert the display end of the keypad into the KeYPRo.
make sure that it is fully seated and that the wider part
of the keypad is fully encased in the wider part of the
KeYPRo.
4. finally, gently work the cable the rest of the way through and carefully
stretch the thin part at the bottom of the KeYPRo over the cable’s strain
relief. again, be very careful that you neither tear the thin part of the
KeYPRo, nor do any damage to the strain relief.
think of the KeYPRo as a bumper for your keypad. this small investment
may save costly repairs in the future.
