[ARM]
Used to activate the data capture mode. Works with or without the
chart
paper
running.
[TRIG]
Manual trigger for data capture.
[SYS]
System key used for setting up various parameters for the Dash 4u.
Design or modify an existing chart. Edit text labels. Set up data
capture and triggering. Save or recall a system set up (Zip disk).
Other system functions such as real-time clock, display colors,
defaulting settings and software upgrade.
[MODE]
Select and run any of the four available charts. Select data logger
(numeric), timed recording or dual speed mode. Select captured data
to review as well as importing and exporting data to Zip disk.
4. REAL-TIME RECORDING FUNCTIONS
•
Four available chart formats: Design grid for number of channels. Pick to overlap some, all or none of the channels.
•
Data logger (numeric output): Select rate at which to print values.
•
Timed recording: Pick one of four charts. Select the start and end times for recording.
•
Dual Speed Recording: Select two chart speeds at which to run the paper and select either the trigger or time duration
to switch between the speeds. The most common use is recording at the first selected chart speed, utilizing waveform
triggering to change to the second chart speed for a predetermined amount of time. At that point, the recorder will
automatically switch back to the first selected chart speed, awaiting another trigger.
During real-time recording, the display will show your signals. At the same time, you can print to paper using the
[RUN / HALT]
key.
5. SETTING UP CHARTS AND GRIDS
The Dash 4u gives you total control over chart layout. You can set individual channel widths, channel location, grids
ON/OFF and major/minor division sizing. You are also able to suppress or enable waveform printing as well as vary the
waveform trace thickness. Further, you can overlap some or all of the channels.
DEFAULT CHARTS
The Dash 4u has four programmable charts. They are defaulted at the factory
prior to shipping. The defaulted charts are four grids, six grids, one grid, and
four grids with eight event markers. You may find this a convenient place to
start.
At any time, you can default the charts as follows:
[SYS] [CUSTOMIZE CHART] [DEFAULT ALL CHARTS]
RUNNING A CHART
[MODE] [RUN CHART
X
]
where
X
= 1 or 2 or 3 or 4.
Immediately, you will see the waveforms scrolling across the color display as
well as the chart paper begins to run. Use the
[RUN / HALT]
key to stop the
paper.
