SECTION 4
MAINTENANCE
24
Replacing Feed Rollers
1.
Before removing Feed Roller Access Plate,
unplug Printer.
2.
Use a Phillips screwdriver to remove four
screws from Feed Roller Access Plate.
Remove Access Plate.
3.
Determine which type of Roller
(A or B)
is
installed on Printer. (
Type B replaced Type
A which was installed on machines
manufactured before May 2012
.)
NOTE: All replacement Feed Roller
Assemblies are type B.
:
[A]
Ridged tread, 2
pc. Feed Roller.
To Remove:
Rotate Feed Roller
Shaft so Feed
Roller mounting
screws are face up.
Use a 3/32-inch Allen wrench to remove
two button head cap screws. Remove one
half of Feed Roller. Rotate Shaft until two
screws holding second half of Feed Roller
are accessible. Remove those screws, then
remove second half of Feed Roller.
[B]
Smooth tread,
1 pc. Feed Roller.
To Remove:
Rotate Feed Roller
Shaft so Feed
Roller mounting
screws are face up.
Use a 3/32-inch
Allen wrench to
remove two button head cap screws. Rotate
shaft until remaining two screws holding
Feed Roller are accessible. Remove those
screws, then open and remove Feed Roller.
4.
Fit new Feed Roller around Shaft, align
holes and replace two screws. Rotate Shaft
and reinstall remaining two screws.
5.
Replace Feed Roller Access Plate and fasten with four Phillips screws.
Summary of Contents for ASTROJET 1000P
