The parameters of the guiding in both modes are set from the panel
EQMOD Applications
(http://eq-mod.sourceforge.net/docs/EQASCOM_Guiding.pdf).
For the ASCOM PulseGuide mode, not required additional blocks and cables. Enough as
an auto guide, use ASCOM EQMOD app.
Further actions for guiding follow the documentation for EQMOD.
It is also possible to stand-alone guide through the ST-4 port without using a PC. For
example, if a camera is used for astrophotography, then a laptop or PC is not needed.
Photos can be saved on the flash memory of the camera. In this case, Skywatcher
SynGuider - Stand Alone Autoguider can be used as an auto-guide. At the same time, the
EQStar must have stand-alone guided mode enabled via the ST-4 port. To enable stand-
alone guided mode, first connect the joystick to the EQStar. Press and hold the MODE
button for 5 seconds until a long beep sounds. EQStar has now switched to stand-alone
mode guided via the ST-4 port. By default, the guiding speed is set to x0.5 for each axis.
The RA + button allows you to set 3 guiding speeds for the RA axis - x0.5, x0.75 and
x1.0. With the DEC + button you can set 3 guiding speeds for the DEC – x0.5, x0.75 and
x1.0 axes. Moreover, each press will lead to a change in speed in a big direction, and
will be accompanied by corresponding sound signals. To deactivate the autonomous
powering mode, also press and hold the MODE button for 5 seconds.
Pinout port ST-4 EQStar
5. MOUNT CONTROL FROM MOBILE DEVICES.
5.1 Follow steps 3.1, 3.2.
5.2 Connect the mount control unit to the WiFi module using the DB9 connector. After
turning on the power a signal will sound, indicating that the CS is ready to mounting
control with MD. Mount the telescope should be correct align a level and relative to
