Operation
900079-00, 02/2014
Innovative Hearth Products
Astria™ Sirius Linear Direct-Vent Gas Fireplaces
62
LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result,
causing property damage, personal injury, or loss of life.
A.
This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot by hand.
B.
BEFORE OPERATING smell all around the appliance area for gas. Be
sure to smell next to the floor because some gas is heavier than air
and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
s
Do not try to light any appliance.
s
Do not touch any electric switch; do not use any phone in your building.
s
Immediately call your gas supplier from a neighbor’s phone. Follow the
gas supplier’s instructions.
s
If you cannot reach your gas supplier, call the fire department.
C.
If any portion of this appliance does not operate as the instructions
indicate, do not try to repair it, call a qualified service technician.
Do not use tools. Force or attempted repair may result in a fire
or explosion.
D.
Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any
gas control which has been under water.
LIGHTING INSTRUCTIONS
1.
STOP! Read the safety information above on this label.
2.
Read this manual including the remote control system section.
3.
Slide the switch on the receiver to OFF.
4.
Press ON/OFF button on remote control transmitter to OFF.
5.
Turn OFF all electric power to the appliance.
NOTE:
The control has a battery backup (remove batteries
).
NOTE:
This appliance is equipped with an ignition device which automatically
lights the pilot. Do not try to light the pilot by hand.
E.
Wait five (5) minutes to clear out any gas. If you then smell gas,
STOP! Follow
B
in
FOR YOUR SAFETY READ BEFORE LIGHTING
. If
you do not smell gas, go to the next step.
6.
Turn ON all electric power to the appliance.
NOTE:
The control has a battery backup (install batteries).
7.
Slide the switch on the receiver to REMOTE.
8.
Press ON/OFF button on remote control transmitter to ON.
9.
If applicable, set thermostat on remote control transmitter to desired setting.
10.
If the appliance will not operate, follow the instructions
TO TURN
OFF GAS TO APPLIANCE
and call your service technician or
gas supplier.
1.
Slide the switch on the receiver, wall switch or ON/OFF
switch to "OFF.
2. (if applicable) Press ON/OFF button on remote control
transmitter to "OFF."
P/N 580491-01, REV. 00
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
A. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot by
hand.
B. BEFORE OPERATING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
s
Do not try to light any appliance.
s
Do not touch any electric switch; do not use any phone in your
building.
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
WARNING
HOT GLASS WILL CAUSE BURNS.
DO NOT TOUCH GLASS UNTIL COOLED.
NEVER ALLOW CHILDREN TO TOUCH GLASS.
s
Immediately call your gas supplier from a neighbor’s phone.
Follow the gas supplier’s instructions.
s
If you cannot reach your gas supplier, call the fire department.
C. If any portion of this appliance does not operate as the
instructions indicate, do not try to repair it, call a qualified
service technician. Do not use tools. Force or attempted
repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and
any gas control which has been under water.
Electronic Gas Control
Valve - SIT
Electronic Pilot Assembly
3. Turn off all electric power to the appliance if service is to
be performed.
Note: The control may have a battery backup
(remove batteries, if installed).
4. Close the main line gas shut-off valve.
1. STOP! Read the safety information above on this label.
2. Read the Care and Operation manual including the section on
"Remote Control System," (if applicable).
3. Slide the switch on the receiver, wall switch or ON/OFF switch
to "OFF."
4. Turn "OFF" all electric power to the appliance. Note: The control
may have a battery backup (remove batteries, if installed).
5. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot by hand.
6. Wait five (5) minutes to clear out any gas. If you then smell
gas, STOP! Follow “B” in the safety information above on this
page. If you do not smell gas, go to the next step.
7. Turn on all electric power to the appliance. Note: The control
may have a battery backup (install batteries, if applicable).
8. Slide the switch on the receiver to REMOTE or ON/OFF switch /
wall switch to ON.
9. (if applicable) Press ON/OFF button on remote control
transmitter to "ON."
10. (if applicable)
Set thermostat on remote control to desired
setting.
11. If the appliance will not operate, follow the instructions "To
Turn Off Gas To Appliance" and call your service technician or
gas supplier.
Remote
Off
On
PRG
Wall Switch
Receiver
ON/OFF Key
THERMOSTAT
Key
Remote Control
Transmitter
Electronic Gas
Control Valve
Electronic Pilot
Assembly
TO TURN OFF GAS TO APPLIANCE
1.
Slide the switch on the receiver to OFF.
2.
Press ON/OFF button on remote control transmitter to OFF.
3.
Turn OFF all electric power to the appliance if service is to
be performed.
NOTE:
The control may have a battery backup (remove batteries, if installed).
4.
Close the main line gas shutoff valve.
WARNING
Hot glass will cause burns.
Do not touch glass until cooled.
Never allow children to touch glass.
