INNOVATIVE HEARTH PRODUCTS • SIGNATURE SERIES DIRECT-VENT GAS FIREPLACES • ENVY TRADITIONAL • INSTALLATION INSTRUCTIONS
6.
Apply a small amount of pressure against the door to hold it
in position. Then, release the two upper latches.
7.
Carefully grip the glass door at the top and bottom, and
remove it from the fireplace.
NOTE:
Place the glass door in a secure location where it will
not be damaged until reinstrallation.
INSTALL THE LOGS AND DECORATIVE VOLCANIC STONE
NOTE:
Turn OFF all electricity to the appliance before
installing volcanic stone, and logs.
NOTE:
The log set and burner are designed to provide an
artistic, asymmetrical fire. The fire does not burn in the left rear
quarter of the log set.
1.
Align the two holes in the bottom of Log 1 over the two tabs
at the rear of the burner (
Figure 2
).
Figure 2: Placing Logs 1 and 2
2
1
2.
Hold Log 1 in position while placing Log 2 on the burner and
resting it against the alignment notch in Log 1 (
Figure 2
).
3.
Place Log 3 in position with the base aligned in the burner
surface (
Figure 3
).
Figure 3: Placing Log 3
3
4.
Insert the left end of Log 4 under Log 3 and position the right end
of Log 4 in the notch on the top, right end of Log 3 (
Figure 4
).
Figure 4: Placing Log 4
4
5.
Ensure all logs are properly positioned on the surface of the
burner and interlocked with each other (
Figure 4
).
6.
Place Log 5 in position in the notches on the upper right
portions of Logs 1 and 3 (
Figure 5
).
Figure 5: Placing Logs 5 and 6
5
6
7.
Place Log 6 in position in the notches near the left ends of
Logs 2 and 3 (
Figure 5
).
8.
If Installed, position and secure the andirons.
9.
Place the volcanic stone generously in front of the burner on
the ramped sub‑floor. In an artistic manner, blend the volcanic
stone with the glowing embers in front of the log set, to
simulate a diminishing ember bed.
FIREPLACE REASSEMBLY
1.
With an ammonia‑free glass cleaner and soft, non‑abrasive cloth,
remove smudges from the inner surface of the glass door.
2.
Carefully position the glass door in front of the firebox
with the gasket properly seated, and hook the two top door
latches over the door frame. Then, hook the two bottom
door latches over the door frame.
3.
Locate the surround trim assembly mounting slots on the
left and right sides of the firebox. Align the surround trim
assembly with the mounting slots and press in and down to
lower the surround into position. Reinstall the left and right
side finish trim gap fillers.
4.
With an ammonia‑free glass cleaner and a soft, non‑abrasive
cloth, remove fingerprints and smudges from the front
surface of the glass door and the surround trim assembly.
P/N 900005-04 Rev. A 10/2014
1508 Elm Hill Pike, Suite 108
Nashville, TN 37210
IHP.US.com
Innovative Hearth Products reserves the right
to make changes at any time, without notice,
in design, materials, specifications, prices and
also to discontinue colors, styles, and products.
Consult your local distributor for fireplace
code information Printed in U.S.A. © 2014
Innovative Hearth Products, LLC .
P900005-04
f i r e - p a r t s . c o m
