PROHEAT II SERIES · HEAT PUMP AIR/WATER SYSTEM
© FLUIDRA 2019 ALL RIGHTS RESERVED. PROPRIETARY DOCUMENT.
ENGLISH
Pag: 11
DANGER OF INJURY BY REFRIGERANT GAS:
Refrigerant gases may cause disorders in heart rate and frostbite in case of
body contact, ingestion or inhalation.
•
Avoid contact with refrigerant gases.
•
Works on refrigeration systems must be carried out by qualified
personnel.
•
When working with refrigerants, do not eat, drink or smoke. Wash
your hands after finishing work.
•
Wear all necessary protection gear: clothing, gloves, glasses ...
•
Work in a ventilated place.
DANGER OF INJURY BY HOT SURFACES:
The surfaces of some components may become hot during operation of
the equipment. Contact with skin can cause severe burns.
•
When working in the vicinity of hot surfaces, wear protection gear:
clothing and safety gloves.
DANGER OF INJURY BY COLD SURFACES:
The surfaces of some components may become cold during operation of
the equipment. Contact with skin can cause severe freeze-burns.
•
When working in the vicinity of cold surfaces, wear protection gear:
clothing and safety gloves.
DANGER OF INJURY BY PRESSURIZED GASES:
Pressurized components of the equipment can leak fluids under high
pressure if they are handled incorrectly or in case of defect and cause
serious injuries.
•
Before working with the pressurized elements, remove the
pressure.
DANGER OF INJURY BY FIRE:
If the fire extinguishing media is not ready for use or is inadequate, serious
injury or death may occur as well as serious material damages.
•
Make sure that there is adequate extinguishing media at the site.
•
Check extinguishing media periodically.
•
Replace or replenish the extinguishing media after each use.
•
When using extinguishers, pay attention to the instructions for use.
DANGER OF INJURY OR DEATH BY FAULTY SECURITY SYSTEMS:
If safety devices are not working correctly or have been tampered with or
manipulated, there is a risk of serious injury, even death.
•
Before starting any work on the equipment, check that all safety
devices are in working order and correctly installed.
•
Do not override or short circuit any safety device.
•
Make sure that all safety devices are accessible at all times.