Astralpool LumiPlus DC V1, Installation And Maintenance Manual

Page: 4 / 36

4
Operation modes
The LumiPlus ECO unit enables different light scenarios to be created inside the swimming pool with two operation
possibilities:
Set colour: Selection of one set colour out of seven possibilities.
COLOUR Nº COLOUR
1 White
2 Red
3 Blue
4 Green
5 Magenta
6 Cyan
7 Yellow
Automatic colour sequence: Selection from among seven programmes of colour sequences. Each programme is defined
by the duration of each colour and of the transition from one colour to another, according to the following table:
SEQUENCE ORDER OF COLOURS
1 Red Blue Green Magenta Cyan Yellow
2 Red Green Cyan Blue Magenta Yellow
3 Magenta Cyan Yellow - - -
4 Red Blue Green - - -
5 Magenta Cyan Yellow - - -
6 Yellow Magenta Cyan - - -
7 Green Red Blue - - -
The colour or sequence is changed by pressing the pushbutton. The colour and sequence cycle is rotary. For example,
if you are in colour 5, by pressing once, you will reach colour 6. If you press once again, you will go to sequence 7. If
you are in sequence 7, press once and you will get to colour 2, which is Red.
Colour 1, corresponds to white and is reached by one long press.
6.2.B. LumiPlus TOP: Modulator control and/or Remote control
The system has 20 operation modes: 12 set colours and 8 sequences of different colours.
The Modulator controls switching LumiPlus Flexi On and Off, changes of colour and sequences and switching off ti-
ming. If you have a remote control, apart from the modulator operations, you can also switch colours of a sequence on
and off and select the switching off time.
Electrical connection diagram (see diagram page 30)
The modulator, transformer and LED spotlights are required for an installation to work properly. Optionally, this system
can be controlled by a remote control.
The modulator must be connected to a power supply of 230 V AC through the two terminals marked RED and to the
primary windings of the transformer (230 V AC) through the terminals marked TRF.
The transformer must be sized to supply the corresponding VAs to each LumiPlus that is wired (see table on the back
cover). For example, if you wish to control three 29 VA RGB V1 spotlights they must be wired in parallel to a transformer
of at least 100 VA.
Each modulator can support up to a maximum of 900VA.
Once the unit is connected, proceed as follows to start-up the projector for the first time:
Switch on the unit by activating the 230 V~ac at the input of the Modulator, which will automatically syntonize with
the transformer. The green LED of the Modulator will flash every 2 seconds and the LumiPlus Flexi will remain off.
Types of lighting
The Remote Control – Modulator – Transformer – LumiPlus Flexi unit enables you to create different lighting settings
inside the pool with two operation options:
Set colour: Selection of a set colour among twelve possibilities.
COLOUR Nº COLOUR COLOUR Nº COLOUR
1 Red 7 Pale violet
2 Green 8 Sky-blue
3 Blue 9 Orange
4 Yellow 10 Pink
5 Cyan 11 Emerald green
6 Magenta 12 White