Astralpool HALO DOSER, Installation Manual

Page: 8 / 12

8
HALO ® DOSER ™
installation manual
Correct Installation
Incorrect Installation
Figure 7. Chemical Placement
With the clip of the Halo Doser cable plug facing away
from the wall, plug the dosing pump cable into the
“pH dose” connector on the base of the chlorinator
(right hand side of the chlorinator base). See Figure 8. To
keep the wiring tidy, excess cable can then be pushed
back into the base of the doser pump enclosure.
LIGHT LAN RJ12 RS485 Water
Temp
pH
Dose
Figure 8. Halo Chlor Connections
3.3 Enabling Dosing on the
Halo Chlorinator
If a pH probe is also being installed, the process of
installing the pH probe will automatically enable the
acid dosing pump.
Otherwise, to enable dosing on the Halo Chlorinator,
follow the steps below.
1. The “Install” page is accessed via the settings icon
on the Halo Chlorinator “Home” Page.
Figure 9. Halo Install Main Screen
2. Press “Confi gure” in the “Equipment
Confi guration” section as shown in Figure 9 then
select “Chlorinator”.
3. Move the “Enable Acid Pump” switch to the right
as shown in Figure 10 to enable dosing. Press
the“Back” button twice to return to the main
chlorinator screen.
Figure 10. Halo Chlorinator Confi guration Screen