INST 347 eCombi EE2 Pool & Spa Pump V08.20
7
OPERATION OF CONTROL PANEL
The eCombi EE2 pump incorporates a user panel that allows you to select between low speed and high speed simply by
pressing the desired button. The selected speed will be highlighted by a green LED light above the button.
When plugged into power the pump will automatically start and run on High Speed for 5 minutes. It will then revert to the
speed it was previously set on.
To turn the pump off switch it off at the power point.
USE WITH SUCTION CLEANERS
When connecting a suction cleaner to the eCombi EE2, it is essential that full prime is achieved on the pump prior to connecting
the cleaner hose. During operation at low speeds, the pump may only operate with partial prime in the hair and lint pot
chamber.
To operate a suction cleaner on your pump;
1.
Choose the High speed button.
2.
Allow pump to operate for a minimum of 2 minutes to allow a full prime to be achieved.
3.
Connect cleaner plate and hose to skimmer/wall suction only after all air has been purged from the top of the hair and
lint pot of your Ecombi EE2 Pump.
4.
When cleaner is no longer required, disconnect and remove hose/cleaner plate from system. Select the lowest filtration
speed that keeps your pool clean.
5.
If replacing or selecting a new cleaner, AstralPool recommend an AstralPool Robot Cleaner which operates independently
from the filter pump and allows the pump to operate at a speed which offers the maximum energy (and cost) savings.
USE WITH ASTRALPOOL GAS HEATERS
Gas heaters (and electric heat pumps) generally rely on a water pressure switch to activate the heater control circuit. When
the eCombi EE2 pump operates on low speed the water pressure produced is generally insufficient to activate the pressure
switch and control circuit within the heater.
If using a compatible AstralPool Gas Heater you can select the High Speed on your eCombi EE2 pump to ensure the water
pressure switch is activated and the heater obtains enough water flow to operate correctly.
