A
E
E
H
I
J
J
Figure 1
C
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
ASSEMBLY INSTRUCTIONS
CAUTION:
Do not over tighten fasteners.
2.
(SEE FIGURE 2) Attach the wood seat slats (B)
to the leg and arm supports (C) using bolt (F),
2 washers (H) and nut (J) at each of the tabs
on the leg and arm supports (C). Do not tighten
bolts until all wood seat slats (B) are in place
and bench is upright on the floor to level it for
tightening.
1.
(SEE FIGURE 1) To attach the top of the bench
back (A) to the leg and arm frames (C) use
bolts (E), 4 washers (H) [two on each side of
the bolt] and nuts (J) to the tabs on the top
of the leg and arm frames (C). To attach the
bottom of the bench back (A) to the leg and
arm frames (C) use bolts (E), 4 washers (I)
[two on each side of the bolt] and nuts (J) to
the tabs on the bottom of the leg and arm
frames (C).
1
2
NOTE: This product is intended for residential, non-commercial use.
Figure 3
PARTS & HARDWARE LIST
PART #
DESCRIPTION
QUANTITY
A Bench
Back
1
B
Wood Seat Slats
4
C
Leg & Arm Frame
2
D
Side Seat Brace
2
E
6mm x 32mm Bolt
4
F
6mm x 30mm Bolt
8
G
6mm x 20mm Bolt
2
H 6mm
Washer
28
I 8mm
Washer
8
J Nut
14
K Wood
Screw
6
L
Middle Seat Brace
1
E
K
L
J
F
A
B
C
I
D
G
H
Parts Detail
B
C
H
J
J
H
K
C
G
L
B
D
F
Figure 2
3.
(SEE FIGURE 3) Turn the bench over on a
non-scratch surface. Attach the middle seat
brace (L) to each of the wood seat slats (B) by
placing the middle seat brace (L) in between
the leg and arm frames (C) at the midway
point. Use the wood screws (K) to secure. You
may need to bend the middle seat brace (L) a
little to make it fit the contour of the slats.
4. (SEE FIGURE 3) Attach the side seat braces (D)
to the leg and arm frames (C) using bolts (G),
2 washers (H) and nuts (J). Connect the side
seat braces (D) to the wood seat slat (B) using
wood screws (K). Ensure all fasteners are
securely tightened.
H
I
