A Table
Top
1
B Upper
Table
Leg
1
C Lower
Table
Leg
1
D Bolt
4
E Washer
4
F Hex
Key
1
1.
(SEE FIGURE 1)
Place table top (A) upside
down on a non-scratching surface such as a
piece of carpet, blanket or large towel.
2. Turn the upper table leg (B) upside down so
that the holes at the top of the legs line up with
the holes underneath the table top (A). Then
do the same with the lower table leg (C). The
center support holes should fit flush together.
3.
(SEE FIGURE 2)
Secure each leg (B,C) to the
table top (A) using washer (E) and bolt (D).
4.
(SEE FIGURE 3)
Turn the table right side up.
5. All four legs should sit flat. If the table rocks,
the table legs have been mounted in reverse
order. If so, repeat steps 1 - 3 reversing the
placement order of the table legs.
PARTS & HARDWARE LIST
PART #
DESCRIPTION
QUANTITY
A
B
C
D
ASSEMBLY INSTRUCTIONS
Figure 1
Figure 2
Figure 3
CAUTION:
Do not over tighten fasteners.
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
D
B
E
A
C
NOTE
: This product is intended for residential, non-commercial use.
Parts Detail
E
F
