4. (Figure 4)
Align Corner roof brackets (L) in the
corners of uprights on top of pole sections and
secure with screw, nut & cap sets (F).
FIGURE 6
FIGURE 5
Attach side roof rails (D) to tabs of roof
bracket (K) as shown using screw, nut and cap
sets (H).
5. (Figure 5)
Attach corner roof rails (C) to tabs of
roof bracket (K) as shown using screw, nut & cap
sets (H).
1. (Figure 1)
Assemble the four corner uprights of
the gazebo by attaching upright panels (A) and (B)
as shown using screw, washer and nut sets (G).
Slide the plastic nut cover over nut after
tightening. Place the assembled uprights at each
corner of an approximately 10" square area in a
flat and level location.
CAUTION
Do not over tighten fasteners.
An additional 1/4 turn to 1/2 turn more after
joint becomes snug is adequate.
Overtightening can collapse the frame tubing.
ASSEMBLY INSTRUCTIONS
FIGURE 1
3. (Figure 3)
Place assembled side pole sections on
top of corner uprights and secure with fastener
sets (J).
NOTE: Angled side bracket of side pole
connector brackets (N) should be facing
up and into the center of the gazebo.
2. (Figure 2)
Build the four side pole assemblies by
attaching two side poles (E) to the side pole
connector brackets (N) with screw, nut & cap
sets (I).
FIGURE 2
FIGURE 3
A
B
G
6. (Figure 6)
Lift roof assembly into position and
attach corner roof rails (C) to corner roof brackets
(L) with screw, nut & cap sets (H). Attach side roof
rails (D) to side pole connector brackets (N) with
fastener sets (H).
FIGURE 4
G
I
N
I
E
E
J
N
F
L
C or D
K
H
C
L
D
C
H
3
4
N