General household tools will be needed for assembly.
1. Begin by mounting the legs (C) to the two center support rings (B)
with the nuts (E) (Figure 1).
2.
Holding one of the legs (C) and one support ring (B) together so that
the support ring threaded stud lines up with the hole in the tab
mounted on the leg. Slide the stud through the tab hole.
3. Screw 1 nut (E) onto the bolt until hand-tight.
4. Repeat steps 2 and 3 with the other support ring.
5. Repeat steps 2 - 4 with the other three legs.
6. At this point all four legs should be attached to the two center
support rings
7. Place tabletop (A) upside down on a non-scratching surface such
as the table box, carpet, blanket or large towel (Figure 2).
8. Turn the leg assembly upside down, and place the legs against
the tabletop (A) so that the four holes in the tops of the legs slide
onto the four threaded studs mounted underneath. Thread a
wing nut (D) onto each one, and tighten securely.
9. Tighten each of the nuts (D) attaching the legs to the support rings
securely to ensure stability.
10. Have someone help you turn the table right side up.
PARTS & HARDWARE LIST
A
Table Top
1
B
Center Support Ring
2
C
Table Leg
4
D
Wing Nut
4
E
Nut
8
PART #
DESCRIPTION
QUANTITY
ASSEMBLY INSTRUCTIONS
A
B
B
C
D
E
FIGURE 1
FIGURE 2
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER, CONTACT CUSTOMER SERVICE AT
1-888-424-3354
.
E
C
Carefully remove the contents from the package.
If any parts are missing do not attempt to use the product until they
have been obtained and correctly installed.
D
A
