ASSEMBLY INSTRUCTIONS
1. (FIGURE 1)
Insert table top bumper (
D
) in hole
on top of each leg (B).
2. (FIGURE 2)
Insert legs (
B
) into the
plastic sleeves located underneath
the table top (
A
).secure each leg using
screw (H).
4. (FIGURE 4)
Turn table upright on a level
surface, then tighten all fasteners. Place
bolt covers (
D
) over exposed
bolt
heads.
3. (FIGURE 3)
Insert leg support ring (
C
)
between legs (
B
) and secure with
bolts
(
F
) and washers (
E
). using hex key (I)
Do not completely tighten screws.
1
2
CAUTION: Do not over tighten fasteners.
A
A
A
C
C
PARTS & HARDWARE LIST
PART #
DESCRIPTION
QUANTITY
A Table
Top
1
B Table
Legs
4
C
Leg Connector Bracket
1
D
Rubber Table Top Bumper
4
E Flat
Washer
8
F
Hex Bolts M6x25
8
G
Hex Cap
8
H Screw
M4x16
8
I Hex
Key
1
J Screw Driver 1
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
Parts Detail
NOTE:
This product is intended for residential, non-commercial use.
B
B
B
B
D
D
E
F
G
H
H
I
J
J
Figure 1
Figure 2
Figure 3
Figure 4
E
F
G
I
