"U" BAR
WASHER
BOLT
METAL PLATE
SPRING WASHER
NUT
FOOT CAP
STEEL SPRING PLATE
ROCKER ASSEMBLY
SWIVEL BASE
PARTS
LIST
ITEM
DESCRIPTION
QUANTITY
Carefully
remove
the
contents
from
the
package
．
If
any
parts
are
missing
do
not
attempt
to
use
the
product
until
they
have
been
obtained
and
correctly
installed
．
ASSEMBLY
INSTRUCTIONS
A
Chair Frame
1
B
Swivel Base & Rocker Assembly
1
C
5/16
＂
X25MM Bolt
4
D
8.5X2.0MM Spring Washer
4
E
4
F
5/16
＂
Nut
４
G
Metal plate
2
H
Hex Wrench-1
1
I
Hex Wrench-2
1
NOTE
：
This
product
is
intended
for
residential
，
non
－
commercial
use
．
Parts
Detail
A
B
C
D
E
F
G
H
I
１
２
Figure
1
8.5X1.5MM Washer
Step 1:
Identify all parts packed in carton against the parts list. Remove all protective materials.
Place parts on a non-abrasive surface to avoid scratching.
Step 2:
Place the swivel base (with rocker assembly) on a flat, solid surface. Make sure the
rocker assembly is positioned all the way into the base. It may have shifted or vibrated
out during shipment.
Step 3:
Important: We recommend 2 people work together to assemble the chair.
Note the
arrow labels on the "U" bar and the rocker assembly. Also note the horseshoe shape of
the rocker plate. Point the open end of the horseshoe away from you. The arrows on
the rocker assembly should be pointing towards you. Set the chair frame on the rocker
assembly with front of the seat facing you and the arrows on the "U" bar pointing
towards you ( See diagram). This is very important for a safe, balanced rocking motion.
If chair frame has been properly positioned
on the rocker assembly, all arrows on
the "U" bar and rocker assembly will be pointing in the same direction.
Step 4:
Critical Step:
The two metal plates must be installed in the proper location. Read this
step and carefully examine the diagram. Guide the bolts and washer through the holes in
the "U" bar, through the holes in the steel spring plate, through the hole in the metal plate,
beneath the steel spring plate, add a spring washer and a nut to each bolt as shown in the
diagram.
Hand tighten nuts 3-4 revolutions only.
Repeat the same procedure on the
other side.
CAUTION:
Failure to place metal plates under the rocker plates and above the "U"
bar exactly as shown in diagram will cause the bolt heads and nuts to damage the
structure of the rocker plates and the "U" bar. Damage due to over tightening of
bolts or improper assembly could cause injury and may void your warranty.
Step 5:
Tighten all nuts and bolts with the hex wrenches provided.
Do not over tighten.
Remove arrow labels from "U" bar and rocker assembly.
Step 6:
Your chair should be ready for use. If your chair is not rocking properly, double-check
your assembly procedure, especially Step 3. If the chair rocks too far forward to or is
difficult to rock backwards, you have probably installed the seat frame backwards on the
rocker assembly. If you need further assistance.
