11
STANDARD SETTING
Switch off the unit. Press the key "1" and turn
the power on. All settings are as follows:
CHANNEL A:
-auto (sequential) mode
-8 inputs
-seq. time - 1 sec.
CHANNEL B:
-sequential mode
-seq. time - 1 sec.
-8 inputs
-1 frame
ALARM:
-activity - off
-seq. time - 1 sec.
-duration time - 20 sec.
-frame sw. - off
-trigger - negative
REMOTE CONTROL:
-off
LINE-LOCK:
-phase - 0
ON-SCREEN:
-number display - on
-time display - on
SELF TEST
Switch off the unit. Press the key "4" and turn
the power on. All video inputs are sequentially
switched to the both output channels
accompanied with blinking LEDs. Buzzer is
activated, SELF-TEST message is on the
screen.
INSTALLATION
This unit is fully assembled prior to shipment,
and is ready to operate immediately after
unpacking.
If there are any problems in ground loop-through
between video sources (cameras, VCR etc.) and
this unit, remove the seven screws on the
cover
′
s upper panel and open the upper lid.
Then remove the GND connector from PCB.
The video switcher ground will be separated
from the cover and earth.
Note:
•
When the GND connector is removed it has to
be isolated.
TABLETOP UNIT
This unit is fitted with rubber feet on the base
plate for use as a tabletop unit.
RACK MOUNTING
For rack mounting, remove the rubber feet and
use the optional rack mounting kits.
