5
INSTALLATION
The unit is suitable to use CAT 5 or other UTP (Unshielded Twisted Pair) cables, where is possible to
connect one or more units and enable to pass more than one video signal through the same cable.
(1) Connect the video output BNC connector with cable to the video monitor.
(2) Connect the twisted-pair cable to the video input terminal block connector.
(3) Connect the power supply unit. (AC or DC)
(4) Remove the jumper
J1,
for the distances up to 450m.
(5) Switch-on the video monitor.
(6) Switch-on the power supply unit.
(7) Check the video signal on the video monitor.
(8) If there is too much noise in the signal, for the distances longer than 100m, set the pre-emphasis to
10 dB
in the video twisted-pair transmitter.
(9) Check the video signal on the video monitor.
(10) If there is still too much noise in the signal, for the distances from 450m to 750m insert the jumper
J1.
For the distances longer than 750m, remove the jumper
J1
and insert the jumper
J2.
Maximum distances (CAT 5 UTP Cable) between different models of video twisted-pair transmitters and
receivers:
Model
TT 101
TT 101S
TTP 101
TTR 101
TTR 202
TTM 101
TTM 101C
TR 101
1600 1600 1800 1600 1600 1800 1800
TR 101L
1500 1500 1500 1500 1500 1500 1500
TR 101LS
1500 1500 1500 1500 1500 1500 1500
TRP 101
1600 1600 1800 1600 1600 1800 1800
TRP 101L
1500 1500 1500 1500 1500 1500 1500
TR 404L
1500 1500 1500
1500 1500 1500 1500
TR 404LP
1500 1500 1500 1500 1500 1500 1500
TR 808L
1500 1500 1500 1500 1500 1500 1500
TR 808LP
1500 1500 1500 1500 1500 1500 1500
TR 1616L
1500 1500 1500 1500 1500 1500 1500
TR 1616LP
1500 1500 1500 1500 1500 1500 1500
TRR 101
1600 1600 1800 1600 1600 1800 1800
TRR 101L
1500 1500 1500 1500 1500 1500 1500
TRR 202L
1500 1500 1500 1500 1500 1500 1500
TRM 101
850 850 900 850 850 900 900
TRM 101C
850 850 900 850 850 900 900
