LIMITED WARRANTY
Associated Equipment Corporation, 5043 Farlin Ave., St. Louis, Missouri 63115, USA, makes this
limited warranty to the original purchaser at retail of the Battery Tester Model 6030.
The Company hereby warrants to the Purchaser that if the Product, or any part thereof, shall prove to
be defective due to improper workmanship or materials at any time up to and including one (1) year
from the date of Product's purchase at retail, then the Company shall repair or replace the Product, or
any part thereof, as the case may be, at the Company's option, without charge to the Purchaser for
parts and labor, provided that Purchaser follows the procedures set forth herein.
This limited warranty does not and shall not apply: (1) to any Product parts subject to normal wear
and tear, including, but not limited to, clamps and cables, (2) if the Product, or any part thereof, is
subject to accident, misuse, abuse, or operated contrary to the Company's instructions pertaining to
the Product, or (3) to the Product, or any part thereof, damaged by alteration, or by improper repair or
service not rendered by the Company.
To obtain warranty repairs, the Purchaser must take the following steps:
(1) Carefully and securely pack the Product for shipping. The Company is not and shall not be
responsible nor liable for damage to the Product caused by or during shipping.
(2) ENCLOSE PROOF OF PURCHASE AT RETAIL BY PURCHASER.
(3) Send the Product, with all postage, transportation and delivery charges prepaid, to
Associated Equipment Corporation, 5110 Brown, St. Louis, Missouri 63115.
(4) Request "Warranty Service" in writing. If the Purchaser does not request "Warranty Service" in
writing, the Product will be returned to the Purchaser at the Purchaser's sole cost and expense with
the Purchaser being charged for repairs or replacement. The Company assumes no responsibility for
cost or damages incurred by the Purchaser resulting from the Purchaser's improper request for
Warranty Service.
(5) Include a brief description of the problem.
If the problem is within the coverage of this limited warranty, the replaced or repaired Product will be
returned to the Purchaser at the Company's sole cost and expense. If the problem is not within the
coverage of this limited warranty, the product will be returned to the Purchaser after receipt of his
Bank Card information and a charge may be imposed for a repair cost estimate.
THIS IS THE ONLY EXPRESS LIMITED WARRANTY ASSOCIATED WITH THE PRODUCT AND
THE COMPANY NEITHER ASSUMES NOR AUTHORIZES ANYONE TO ASSUME OR MAKE ANY
OTHER EXPRESS WARRANTY WITH RESPECT TO THE PRODUCT OTHER THAN THIS
EXPRESS LIMITED WARRANTY. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE OF THIS PRODUCT IS LIMITED TO A PERIOD OF ONE
(1) YEAR FROM THE DATE OF THE PRODUCT'S PURCHASE AT RETAIL BY THE PURCHASER.
SOME STATES DO NOT ALLOW LIMITATION ON HOW LONG AN IMPLIED WARRANTY LASTS,
SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.
ASSOCIATED EQUIPMENT CORPORATION
5043 Farlin Avenue
St. Louis, MO 63115
W2187
Rev.01/06 027-0695
MODEL
6030
BATTERY AND
CHARGING
SYSTEM
TESTER
ASSOCIATED
OPERATOR'S MANUAL
SAFETY INFORMATION
Working in the vicinity of lead-acid battery is DANGEROUS due to EXPLOSIVE
GASES generated by the battery which can be ignited by a spark, cigarette or
flame and blow the battery apart, forcefully showering the area with battery pieces
and acid.
To reduce the chance of exploding batteries follow instructions by manufacturers
of batteries as well as these instructions.
IN CASE OF ACCIDENT RINSE EYES WITH CLEAN WATER AT LEAST 5
MINUTES AND SEE A DOCTOR IMMEDIATELY. NEVER USE EYE DROPS
OR OTHER MEDICATION UNLESS DIRECTED BY A DOCTOR.
When around lead-acid batteries wear eye protection and avoid touching or
rubbing the battery as well as clothing, skin and eyes. NEVER smoke, have an
open flame or sparks near battery. Have plenty of ventilation and keep your face
as far as possible from the battery. Undercharged lead-acid batteries will freeze
during cold weather. Never test or charge a frozen battery. Do not allow tools to
drop onto a battery. Do not lay tester on battery.
BATTERY LOAD TEST
1. Turn off engine and all accessories.
2. Connect negative (black) clamp to the negative (NEG, N, - ) battery post.
Connect positive (red) clamp to positive (POS, P + ) battery post. “Rock”
clamps back and forth to insure a good electrical connection. For batteries
with side terminals, use the adapters in clamps.
3. With the clamps connected, the tester’s display will indicate the battery’s
STATE OF CHARGE by displaying the battery open terminal voltage. If the
voltage is less than 12.4 volts, the battery should be recharged before testing.
When the battery voltage is below 12.4, the tester display will alternately
read the battery voltage and the message CH, instructing the battery must be
charged. If recharging does not bring the voltage above 12.4, than the
battery is defective.
