SHOCK BUILD:
BAG 9
GATE 04
14
SHOCK BUILD:
BAG 9
GATE 02
SHOCK BUILD:
BAG 9
GATE 03
x1
x1
x1
x1
x1
x1
42080
Shock Cap, Enduro,
Plastic
Shock Bleeding Steps:
1.
Pull shock shaft down.
2.
Fill shock body 3/4 full with silicone fluid.
3.
Slowly move the shock shaft up and down to remove air from
under piston.
4.
Wait for bubbles to come to surface.
5.
Fill shock body to top with silicone fluid.
6.
Place a drop of oil in the cap and on cap threads.
7.
Install cap and tighten completely.
8.
Slowly compress shaft all the way to the top. If there is
pressure at the top of the stroke, there is too much oil or air.
You must bleed it out.
9.
Slowly pull shaft out.
10.
Unscrew the cap 3/4 turn and tilt the shock at a slight angle.
11.
Slowly compress the shaft to push out excess oil and air.
You should see bubbles coming out from under the cap.
12.
With the shaft compressed, tighten the cap and re-check for
pressure at the top of the stroke. If there is still pressure,
repeat steps 9 thru11.
42081
O-Ring,
Shock Collar
42079
Shock Collar,
Black, Aluminum
42080
Shock Spring Cup,
Plastic
3mm
42089
Front Shock Spring,
Gray, 1.49 lb/in, 63mm
42090
Rear Shock Spring,
Blue, 2.09 lb/in, 63mm
SHOCK FL
UID
#5422
SHOCK FL
UID
#5422
Step 8-12
Step 1-3
Step 3-4
Step 5-6
Step 7
NOTE:
Build 4
complete shocks
NOTE:
Build 4
complete shocks
x1
x1
x1
x1
x1
x1
x1
x1
x1
x1
x1
x1
x1
42054
FT Pivot Ball,
Steel, 6mm
42054
FT Pivot Ball,
Steel, 6mm
42256
Nut
42256
Nut
42263
Nut
25187
3x14mm
BHCS
41091
3x20mm
LP SHCS
41091
3x20mm
LP SHCS
42055
Pivot Ball,
Upper Shock
42055
Pivot Ball,
Upper Shock
42260
Shim,
3mm
42260
Shim,
3mm
42263
Nut
x1
25187
3x14mm
BHCS
SHOCK CAP
O-RING
SHOCK COLLAR
O-RING
