6
An ASSA ABLOY Group brand
P/N AYRD210-INST-FUL Rev E
1. Install bolt in door.
NOTE: The bolt must be in a retracted (unlocked) position
when installing the lockset.
Attach with (2) M4 x 25.4mm [8-32 x 1"] screws supplied.
2. Install strike on the door frame, making sure to allow
for the bolt to be centered in the strike.
3. Install outside escutcheon.
As you position the outside escutcheon, route the
cable through 2-1/8" diameter hole (Figure 3A).
INSTALL LOCK
Figure 3B
Figure 3A
(2) M4 x 25.4mm
[8-32 x 1"]
Flat Head
Combination Screws
(2) M4 x 25.4mm
[8-32 x 1"]
Flat Head
Combination Screws
1
2
NOTE: Cable goes under bolt (see Fig. 3B).
5. Secure both assemblies using (2)
M6 x 59.5mm pan head machine
screws (Fig. 4B), making sure that
outside escutcheon is vertically
aligned. Hand-tighten until snug.
Do not over-tighten.
Figure 4B
Inside of Door
Figure 4A
“Tongue”
Inside of Door
4. Holding the outside escutcheon flush to the door,
position the inside mounting plate by first routing the
wire harness through the mounting plate's 1/2" hole
(Fig. 4A), then inserting mounting plate “tongue“ into
groove at bottom of outside escutcheon.
