P/N YRD136-MNL-0008 Rev C
15
Resetting Lock to Factory Default
When lock is reset to factory defaults all
user codes (including the Master PIN
code*) are deleted and all programming
features are reset to original default
settings (see "Factory Default Settings").
1. Remove the battery cover.
2. Remove the batteries.
3. While pressing the reset button
(minimum of 3 seconds) reinstall
batteries. Release reset button.
4. Replace battery cover.
Upon reset, Master Code creation is the
only option available and must be
performed prior to any other
programming of the lock.
NOTE: After setting the Master Code,
press any key to complete handing of
the lock.
Enrolling Lock In Z-Wave Plus Network
Your network controller first needs to be in
enrollment or exclusion mode for the lock
to be enrolled or removed from network.
Once you put the controller in the
enrollment or exclusion mode, the lock
can be enrolled or removed in the Z-Wave
Plus Plus network by pressing the
button.
To enroll lock using the button option:
1. Remove the battery cover.
2. Press button and hold until unit beeps
two (2) times.
3. Release button and network joining
automatically begins.
4. Replace battery cover.
To remove lock using the button option:
1. Remove the battery cover.
2. Press button and hold until unit beeps
five (5) times.
3. Release button and network removal
automatically begins.
4. Replace battery cover.
Use this procedure only
when network primary
controller is missing or
otherwise inoperable.
