40
ASSA ABLOY Hospitality
66 1100 005-11
5.2 Web interface
If the parameters for the Ethernet module need to be modified to suit the
network where it is located, this can be done via a web interface; see screenshot
with example values in Figure 68. An explanation of some parameters is found in
To modify the parameters:
Figure 68
1. Press the Ethernet module button shown
in
and then release the button.
2. Look in SysMon to see what IP address
the Ethernet module has; see details in
3. In the web browser, enter
.
See example below:
4. Make the desired changes in the
Ethernet
Lock Interface
Setup
page; see example
in Figure 64.
5. If the
server IP
should be changed and there
is no DNS (
domain name system
), either
enter the applicable
Server IP
or
m
ake sure
that the radio button 'Enable' is marked for
Announcement Broadcast
; this makes
the Ethernet module find the server.
6. When all desired changes have been done
in the web interface: click
Save
, then click
Reboot
and press the reset button on the
Ethernet module again to close the
web interface.
Dynamic IP address
Enable/Disable
; if this parameter is set to 'Enable', the Ethernet
module retrieves an IP address via DHCP (
Dynamic Host Configuration
Protocol
) and then automatically finds the server
Host IP
IP address for the Ethernet module
Default gateway
This is the subnet unit to which all IP packets that are heading
for an address outside the subnet should be addressed, i.e. the
IP address for the router of the concerned subnet
Subnet mask
A mask used to determine what subnet an IP address belongs to
Announcement broadcast
Enable/Disable
; makes the Ethernet module find the server
Table 5: Description of Ethernet module parameters
