V3.5 14/08/19
UD0089
Page 628
This Document is uncontrolled unless over stamped "CONTROLLED DOCUMENT"
3.19.32.2
SECURITY SEAL CONFIRMATION OPERATION
To setup an iFob to Prompt for Security Seal Confirmation:
1.
From the Traka 32 system viewer right click over an iFob and click
2.
Click the iFob Details tab.
3.
Ensure the System and iFob selected is correct.
4.
Enter the Security Seal No. in the iFob Description field.
5.
Click Prompt For Security Seal Confirmation to Enable.
6.
Click Save and Close, the system will be updated.
7.
When a User tries to remove an iFob with Prompt For Security Seal Confirmation enabled, the Traka cabinet
LCD will display:
8.
The user must then check the security seal no. on the iFob and compare it to the LCD before pressing * for
different or # for correct from the keypad.
a.
If # is pressed, the system will release the iFob.
b.
If * is pressed, the system will not release the iFob and the LCD will display:
A "Security Seal Different Please Check!" event is recorded in the database viewable from Traka 32
NOTE:
If the User confirms the security seal no. is different, the system will NOT permanently lock the
iFob in place until the condition is resolved. Any user with authorization can still take the iFob. This
feature is designed to notify only by logging a "Security Seal Different Please Check!" event in the Traka
database!
NOTE:
It is the responsibility of the user removing the iFob to verify whether the security seal no. is
correct or different.
