02/11/11
A7763B 17
Copyright © 2011, Sargen
t Manufacturing Company
, an A
SS
A AB
LO
Y G
roup company
. All right
s reser
ved
.
Reproductions in whole or in par
t without express writ
ten permission of Sargen
t Manufacturing Company is prohibited
.
Profile Series v.S1 PoE Cylindrical Lock
Step #11 – Ciruit Board Wiring
Before installing escutcheon, route raceway cables and ground attach to
front of circuit board.
Turn the controller assembly over:
1. Route the raceway connectors over the top of the controller assembly
and plug into the front of the circuit board (side that faces out when
mounted (J7, J4; Fig. 12A).
2. Route the 2 ground ring terminals, one from the lock and the other
from the hinge wiring, over the top of the controller assembly and con-
nect both to the top escutcheon screw.
Note: Connectors go on only one way.
Do not offset connectors and make sure they are completely seated.
Inside.of.Door
Ground
Ring
Terminal
Fig..11A
Step #12 – Install Inside Escutcheon
1. Gently fold the excess ribbon connector and ground wire into the
top hole, JST connectors and ground wire into offset middle hole,
and mortise and AX/DPS wires into bottom hole, being careful not
to pinch wires (Fig. 12A).
2. Insert (2) #8-32 x 1-1/4” screws through inside escutcheon and
thread into outside escutcheon (Fig. 12B).
3. Straighten escutcheons and check that latch screws
are tightened securely.
Inside.of.Door
Fig...12B
Latch Screws
Fig...12A
