B
ackcheck range
D
elayed action
range
C
losing speed
range
L
atching speed
range
1/8" hex socket
wrench
Use 1/8" hex wrench
to adjust valves
2
Adjust
Door speed, and Latching
speed valves to achieve the desired closing time. Recommend
6 seconds minimum from 90° to the closed position.
If
Backcheck
is required, adjust valve to achieve a slight cushioning effect. Auxiliary stop required.
If closer is equipped with
Delayed Action
, regulate valve to achieve the desired delay
Adjusting Closing Speeds
Door Width
Exterior Doors Interior Doors
(Inches)
24-30
TURN nut 1-3
TURN nut 1-3
30-36
FACTORY SET
FACTORY SET
36-42
TURN nut 1-4
TURN nut 1-3
42-48
TURN nut 7-9
TURN nut 4-6
Install cover as shown
SPRING POWER ADJUSTMENT GUIDELINES
Decrease
Increase
Adjusting Nut
5/8"
Insert is removable.
Place in unused opening.
Slide track over roller and install end caps. Se-
cure track to frame with screws provided.
Holder/Bumper option end toward hinge
Assemble arm to closer with index mark on end of
spindle 45º from axis of arm as illustrated below.
Use washer and screw to retain arm (Right hand
door shown).
LEFT HAND DOOR
RIGHT HAND DOOR
5
4
Adjust closing power to the minimum required to reliably close and latch door.
- If door is hard to open, decrease power slightly.
- If door does not latch, increase power as required.
- Use the chart as a starting point.
- Doors adjusted with high closing power to overcome
strong draft conditions may exceed ADA standards.
3
A7347B
TENSION AD-
JUSTER
HOLDER
DEVICE
Mounting screw
A7347B
Copyright © SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing is prohibited.
Copyright © SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing is prohibited.
