IS91DCP 05/20
Copyright © 2016, 2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
3
Model 91DCP,
Metal Frame
A. Verify frame and door installation.
1.
Determine if right hand or left hand
installation. (Figure 1)
2. Verify frame is square by using a
carpenter’s square. (Figure 2)
3. Note if gaps between door and frame are
consistent. Gap should be 1/16" (1.6) at
jamb and header.
4. Using supplied templates, confirm all
dimensions of cut-outs.
Installation
Figure 1
Figure 2
Figure 3
Left Hand Shown
B. Install closer.
1. Install closer in prepped frame with
four (4) 1/4-20 x 5/8" FHPMS mounting
screws provided. (Figure 3)
NOTE: Mounting plate should be flush
with frame rabbet.
D. Attach arm.
1. Using provided 5/32" hex wrench and
1/4-20 x 3/4" Allen Drive with Patch
screw and washer, attach arm to closer
spindle. (Figure 5)
IMPORTANT: Arm should rest at
15° away from door side of closer
mounting plate. Arm always rotates
in direction of door.
C. Install cover plate.
1. Install cover plate to closer mounting
plate with six (6) 6-32 x FHPMS
mounting screws provided. (Figure 4)
Figure 4
Figure 5
