5
80-9360-6007-152 04/18
DC6210 and DC6410 Series Closers
A14 Heavy Duty Friction Hold Open Parallel Arm
Installation Instructions
Copyright © 2018 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
Figure 5
4. Fasten Soffit Plate to Frame Soffit (under
side of frame).
5. Connect Arm To Closer. (Figure 5)
Using hex wrench provided, close (turn
clockwise) CLOSING SPEED VALVE (see
page 5 for location on closer).
DO NOT
OVER TIGHTEN.
• Open door to approximately 60°.
• Using wrench on underside of spindle,
rotate spindle approximately 135° toward
hinge edge of door.
• Install arm on spindle at an approximate 90°
angle to door.
• Reopen CLOSING SPEED VALVE.
• Install and tighten arm washer and screw.
D
O
O
R
SPINDLE
ARM
CENTERLINE
ALL ANGLES SHOWN ARE APPROXIMATE
D
O
O
R
90°
SPINDLE
ROTATED 135°
Rotate 135°
SPINDLE AT REST
60°
DOOR
135°
WRENCH
90°
ARM
2
Installation
6. Adjust Hold Open Position. (Figure 6)
Open door to desired degree of hold open. (If
door does not open far enough, loosen Hold
Open Adjustment Nut.) Place door at desired
degree for hold open and tighten Hold Open
Adjustment Nut.
Rotation:
Counter-clockwise will increase (+) angle.
Clockwise will decrease (-) angle.
NOTE: Pushing door beyond set hold
open point may cause damage to product.
Friction Hold Open
Adjustment Nut
+
Figure 6