7
TL3700 Series
Installation Instructions
Tubular Lockset
FM271 11/19
Copyright © 2012, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
b
Package Contents
4
2
1
3
5
Spring Housing
Square Mounting Plate
Pilot
Hole
Pilot
Hole
NOTE
To level plate, place
a right angle square
on the flat portion of
the mounting plate.
Figure 8
Figure 1 Description
Req .
1
Lever
(2)
2
Set Screw
(2)
3
Rose Assembly
(2)
4
Mounting Post
(2)
5
Mounting Post Screw
(2)
6
Mounting Plate Assembly
(2)
7
O/S Thru-Bolt Plate Assembly
TL3750 only
(1)
c
Installation
1. Install lock per instructions starting on page 5.
a. Square rose installation begins after spring housing installation.
2. Position square mounting plate over spring housing as seen in Figure 1.
3. Drill two centered pilot holes for the #6 mounting screws in the upper right and lower left portions of
the square mounting plate.
4. Loosely attach mounting plate to both sides of the door with screws.
5. Square top surface of mounting plate to edge of door.
NOTE:
The square edge MUST be on the flat surface of the square mounting plate for proper leveling.
6. Tighten mounting screws.
7. Press rose onto mounting plate, fasten lever with set screw.
