6
80-9330-3003-152 04/18
DC3210 Series Closer
Installation Instructions
A11 or A12 Heavy Duty Spring Stop Parallel Arm
Copyright © 2018 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • [email protected]
2
Installation
3. Mount Closer Body to Closer Bracket.
(Figure 6)
4. Fasten Arm Brackets to Frame
For Frame Templates “1A” and “1B” fasten
main arm bracket to frame. Locate and install
reinforced brackets 615F58 (1A) or 615F59
Kit (1B).
For Frame Template “1C” fasten Flush
Partition Bracket 615F60 to frame face
and install main arm bracket to the 615F60
Bracket.
5. Connect Arm To Closer (Figure 7)
Using hex wrench provided, close (turn
clockwise) CLOSING SPEED VALVE. (Figure
9) DO NOT OVER TIGHTEN.
• Open door to approximately 60°
• Using wrench on underside of spindle,
rotate spindle approximately 135° toward
hinge edge of door.
• Install arm on spindle at an approximate 90°
angle to door.
• Reopen CLOSING SPEED VALVE.
• Install and tighten arm washer and screw.
Holding Pins
1/4-20 x 1/2 OHMS (2)
D
O
O
R
SPINDLE
ARM
CENTERLINE
ALL ANGLES SHOWN ARE APPROXIMATE
D
O
O
R
90°
SPINDLE
ROTATED 135°
Rotate 135°
SPINDLE AT REST
60°
DOOR
135°
WRENCH
90°
ARM
Figure 6
Figure 7
