5
Yale Doorman for Aptus
USER MANUAL
Temporary code
(24 hour code)
If you need to let somebody in, for example a work-
man, you can set a temporary 4-digit code directly
on the door. The code will remain active for ap-
proximately 24 hours or until it is deactivated.
Setting a temporary code
Make sure the door is unlocked and open.
Press # on the keypad (only press briefly).
Read the valid key tag. (The key tag must not be
protected by a PIN code.)
Key in your chosen code, then press #.
Erasing a temporary code
Make sure the door is unlocked and open.
Press # on the keypad (only press briefly).
Read the valid key tag.
Then press #.
2
1
1
Emergency unlocking
If, for example, the batteries for the lock run out,
the normal opening function will not work. Even
if this happens, the lock can always be unlocked.
Emergency unlocking from inside using the knob
Turn the knob in the open direction until the knob
is horizontal. Hold the knob in this position while
pressing the handle down.
Emergency unlocking from outside with 9V battery
Power the lock by connecting a 9V battery, from
the outside, to the poles on the bottom edge.
Then hold your key tag up to the lock to unlock it.
9V batteri
2
Low battery warning &
battery replacement
The lock will give a warning signal well before the
batteries run out. Two types of low battery warn-
ing are given: a spoken message when the lock
is unlocked or locked, and a low battery warning
symbol that lights up on the outside of the lock.
To replace the batteries, open the battery cover
and remove the old batteries. Then insert four new
batteries.
Make sure to insert each battery the correct way
round (+ & -).
Always use AA alkaline batteries.
