43
EN
Configuration
Deletion of the user code
1 Open the device with the key.
2 Press the programming button on the main
circuit board.
3 Activate index input.
+
4 Select the user code index.
1
,
2
or
3
5 Finish the index input.
+
6 Delete the user code.
−
Exit programming mode
The programming mode can be exited in different ways.
· If no keys are pressed on the keypad for fifteen seconds after the programming
mode is switched on, the programming mode is switched off and the previous
code is retained.
· If no other key is pressed for four seconds after entering at least two digits
in programming mode, the programming mode is also switched off and the
previous code is overwritten.
· If you press the key
+
after entering all digits of a code to be programmed,
the new code is accepted and the programming mode is switched off.
· If programming is to be aborted (e.g. due to an input error), this can be achieved
by pressing the key
−
. The previously entered code digits will then not be
adopted, the previous code will remain valid. The programming mode is thus
switched off and must be reactivated if necessary.
· If the maximum possible number of digits (six digits) is reached when a code
is programmed, the code is adopted and the programming mode is
automatically switched off.
