Installation Procedure
The ASRock USB 3.1/A+C provides two external USB 3.1 ports which support
transfer rates up to 10 Gbps. Follow the simple steps below to install the ASRock
USB 3.1/A+C.
Step 1
Power off the PC and unplug the power cord. Detach all other cables from the PC.
Step 2
Remove the side panel from the computer case.
*Refer to the documentation that comes with your PC for details.
Step 3
Locate an available x4, x8 or x16 PCI Express slot on your motherboard and remove
its slot bracket
. To maximize the performance of ASRock USB 3.1/A+C, it is highly
recommended to insert the card into the PCI Express slots which are provided
directly from the CPU.
*Please refer to the PCIe Chapter of the User's Manual.
Step 4
Align the ASRock USB 3.1/A+C with the PCI Express slot and press down firmly
until it is fully seated in the slot. Then secure the card with the slot bracket’s holding
screw.
Step 5
Replace the side panel. Reconnect the power cord and any other cables that were
disconnected.
*Jumper Setup:
Jumper J1 is set to Pin2-3 by default and only allows device charging during S0
(Power On). To enable device charging during S3 (Sleep), S4 (Suspend) or S5 (Power
Off) power states, you need to move the jumper cap placed on Pin2-3 (default) to
Pin1-2.
Note
: Device charging during S3/S4/S5 also requires the motherboard’s PCIe slot to
provide 1 ampere current of +3VSB power for each port.
*Please install driver for
Windows® 7 (32-bit and 64-bit).