7. Connect one end of the USB 2.0 Cable to the
USB 2.0 Header (A)
on the
Thunderbolt 4 AIC. Then connect the other end of the cable to the
USB 2.0
Header (B)
on the motherboard.
8. Replace the PC cover.
9. Reconnect the power cord and any other cables that were disconnected.
Then power on the PC.
2 Connecting the Thunderbolt™ Cable
Connect the Thunderbolt
TM
cable from your Thunderbolt-enabled device to the
Thunderbolt
TM
4 Port
on the Thunderbolt 4 AIC.
* The Thunderbolt
TM
cable is not included in the package.
3 Enabling the Thunderbolt™ Function
After hardware installation is completed, enter the BIOS Setup, go to Advanced\
Intel Thunderbolt and then enable the Intel® Thunderbolt™ function.
4 Installing the Thunderbolt Software in Windows
Place the Support CD into your CD-ROM drive and follow the on-screen
instructions to complete the installation.
5. Connect one end of the DisplayPort Cable to the
DisplayPort IN Port (DP_1)
(A)
on the Thunderbolt 4 AIC. Then connect the other end of the cable to the
DisplayPort Port
(B)
on the motherboard's rear I/O panel or on the graphics
card.
6. Connect one end of the DisplayPort Cable to the
DisplayPort IN Port (DP_2)
(A)
on the Thunderbolt 4 AIC. Then connect the other end of the cable to the
DisplayPort Port
(B)
on the graphics card.
*If you use a Thunderbolt™ Type-C monitor, make sure that you install the
DisplayPort Cables into both
DP_1
and
DP_2
on the Thunderbolt 4 AIC.
Thunderbolt™ cable
DisplayPort Cable
USB 2.0 Cable
Thunderbo
lt
4 AIC
A
B
or
Thunderbo
lt
4 AIC
A
B
Thunderbo
lt
4 AIC
A
B
Thunderbo
lt
4 AIC
A
B