ASROCK S880G EXTREME3, Quick Installation Manual

Page: 30 / 243

3 0 3 0
3 0 3 0 3 0
ASRock 880G Extreme3 Motherboard
EnglishEnglishEnglishEnglishEnglish
Chassis and Power Fan Connectors Please connect the fan cables
(3-pin CHA_FAN1)
to the fan connectors and
(see p.2 No. 9)
match the black wire to the
ground pin.
(3-pin CHA_FAN2)
(see p.2 No. 11)
(3-pin CHA_FAN3)
(see p.2 No. 12)
(3-pin PWR_FAN1)
(see p.2 No. 5)
Chassis Speaker Header Please connect the chassis
(4-pin SPEAKER 1)
speaker to this header.
(see p.2 No. 20)
Power LED Header Please connect the chassis
(3-pin PLED1)
power LED to this header to
(see p.2 No. 19)
indicate system power status.
The LED is on when the system
is operating. The LED keeps
blinking in S1 state. The LED is
off in S3/S4 state or S5 state
(power off).
System Panel Header This header accommodates
(9-pin PANEL1)
several system front panel
(see p.2 No. 21)
functions.
1. High Definition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC’97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don’t
need to connect them for AC’97 audio panel.
E. Enter BIOS Setup Utility. Enter Advanced Settings, and then select
Chipset Configuration. Set the Front Panel Control option from
[Auto] to [Enabled].